/******************************************************// // give it a name: int D1 = 9; int D2 = 8; int D3 = 7; int D4 = 6; int D5 = 5; int D6 = 4; int D7 = 3; int D8 = 2; // the setup routine runs once when you press reset: void setup() { // initialize the digital pin as an output. pinMode(D1, OUTPUT); pinMode(D2, OUTPUT); pinMode(D3, OUTPUT); pinMode(D4, OUTPUT); pinMode(D5, OUTPUT); pinMode(D6, OUTPUT); pinMode(D7, OUTPUT); pinMode(D8, OUTPUT); } // the loop routine runs over and over again forever: void loop() { digitalWrite(D1, HIGH); // turn the LED on (HIGH is the voltage level) delay(200); // wait for a 200 Millisecond digitalWrite(D1, LOW); // turn the LED off by making the voltage LOW digitalWrite(D2, HIGH); // turn the LED on (HIGH is the voltage level) delay(200); // wait for a Millisecond digitalWrite(D2, LOW); // turn the LED off by making the voltage LOW digitalWrite(D3, HIGH); // turn the LED on (HIGH is the voltage level) delay(200); // wait for a Millisecond digitalWrite(D3, LOW); // turn the LED off by making the voltage LOW digitalWrite(D4, HIGH); // turn the LED on (HIGH is the voltage level) delay(200); // wait for a Millisecond digitalWrite(D4, LOW); // turn the LED off by making the voltage LOW digitalWrite(D5, HIGH); // turn the LED on (HIGH is the voltage level) delay(200); // wait for a Millisecond digitalWrite(D5, LOW); // turn the LED off by making the voltage LOW digitalWrite(D6, HIGH); // turn the LED on (HIGH is the voltage level) delay(200); // wait for a Millisecond digitalWrite(D6, LOW); // turn the LED off by making the voltage LOW digitalWrite(D7, HIGH); // turn the LED on (HIGH is the voltage level) delay(200); // wait for a Millisecond digitalWrite(D7, LOW); // turn the LED off by making the voltage LOW digitalWrite(D8, HIGH); // turn the LED on (HIGH is the voltage level) delay(200); // wait for a Millisecond digitalWrite(D8, LOW); // turn the LED off by making the voltage LOW } //******************************************************//