RF radio transmitters, receivers, and transceivers enable wireless transmission and reception of signals and data over long distances.
With the 433MHz receivers/transmitters, you can control and read various types of home automation systems.
See also: Domotica RF 433MHz-
Adapter cable uFL IPX IPEX female to SMA female
Cable to connect an antenna with a female SMA connection to a uFL IPX/IPEX female connector.
Length: ~15cm In stock -
RF Antenna 433Mhz 2dBi built-in/internal
Compact 433MHz (built-in) antenna for transmitting and receiving signals.
Frequency: 433MHz
Gain: 2.0dBi
Impedance: 50Ω
Spiral length: 21mm
Spiral diameter: 4.2mm
Pin length: 13mm
Wire thickness: 0.6mm
In stock -
RF Antenna Di-pole 433MHz 3dBi male SMA
Di-pole antenna for RF 433.050Mhz - 434.790Mhz.
Connection: SMA male
Gain: 3dBi
Cable length: 3m
Impedance: 50Ω
Dimensions: 150.2mm x 17.8mm x 8.7mm (see also last image)
In stock -
RF Receiver Aurel AC-RX2/CS 433.92MHz 650201133G
Aurel AC-RX2/CS wide band, low cost & low consumption ASK receiver on FR4.
- Printed circuit version of the well established long available, AC-RX2 receiver assembled on alumina substrate.
- Same AUREL standard pinout.
- Trimmable capacitor, low current, low antenna radiation and high
insensitivity to power switching noises.
Aurel article number:... In stock -
RF Receiver Aurel RX-4MM3/F 433.92MHz 650201139G
Aurel RX-4MM3/F super-het receiver of AM modulated digital data, working at
433.92MHz frequency. Pin to pin compatible with all OOK
AUREL receivers. High selectivity and sensitivity. Ideal for
applications need a higher noise immunity created by
brushes electrical motor.
Aurel article number: 650201139G In stock -
RF Receiver Aurel RX-4MM5/F 433.92MHz 650201110G
Aurel RX-4MM5/F super-het receiver of AM modulated digital data, working at 433.92 Mhz frequency.
Pin to pin compatible with all OOK AUREL receivers.
High selectivity and sensitivity.
Ideal for applications need a higher noise immunity created by
brushes electrical motor.
Aurel article number: 650201110G In stock -
RF Receiver M4 - 315MHz Momentary - Adafruit 1096
These Simple RF receivers are the easiest way possible to add wireless control, painlessly! There's no programming, configuring or addressing - simply power the receiver with ~5 VDC and press the buttons on our matching RF keyfob remote. When the A button is pressed, it activates the first pin, when the B button is pressed, it activates the second ...
Adafruit Part number: 1096
In stock
-
RF Receiver-transmitter set 433MHz
Set of a 433MHz RF receiver and transmitter module to be used for Arduino projects.
For example, for sending and receiving signals from garage doors, doorbells, power strips, etc.
Receiver module:
- Voltage: 5V=
- Consumption: 4mA
- Sensitivity: -105dB
- Frequency: 433MHz
- Dimensions: 30x13x7mm.
Transmitter module:
- Voltage: 3.5-12V=
- Transmis... In stock -
RF Transceiver 2.4GHz NRF24L01+ (8 pins)
With this NRF24L01+ transceiver (a transmitter and receiver in one) you can easily let 2 or more Arduinos (or other MCUs) communicate with each other!
This transceiver is based on the nRF24L01 chip from Nordic Semiductor and transmits and receives at 2.4GHz.
The plus version has improved range, higher sensitivity and improved data rates.
The NRF24L... In stock -
RF Transceiver 2.4GHz NRF24L01+ with amplifier and antenna
With this NRF24L01+ transceiver (a transmitter and receiver in one) you can easily let 2 or more Arduinos (or other MCUs) communicate with each other!
This transceiver is based on the nRF24L01+ chip from Nordic Semiductor and transmits and receives at 2.4GHz.
The plus version has improved range, higher sensitivity and improved data rates.
The NRF24... In stock -
RF Transceiver 387-464MHz CC1101 with antenna
Operating frequency: 387-464MHz
Working voltage:1.8-3.6V
Instantaneous maximum working current: 30mA
Maximum transmit power: 10mW (+10dBm)
Features:
- 315/433/868/915MHz ISM band
- Support 2-FSK, GFSK and MSK modulation
- Receiver sensitivity -110dBm at 1200 baud
- Minimum operating speed 1.2kbps, the highest 500kbps
- Separate 64-byte RX and TX d... -
RF Transceiver 433/868/915MHz triband nRF905 PTR8000+ with antenna
The NRF905 is a radio transceiver similar to the well-known nRF24L01 but operates on 3 frequencies (433/868/915MHz) instead of just 2.4GHz, has a greater range and has some extra IO pins.
Only downside is that the data rate is only 50Kbps compared to the 2Mbps of the nRF24L01+.
Check out the website link for more information and an Arduino library... In stock -
RF Transceiver 868MHz CC1101 with antenna
The CC1101 is an 868 MHz transceiver module (for transmitting and receiving). The CC1101 module has a maximum range of 300 meters in open field and a sensitivity of approximately -112 decibels. An SPI interface is available for communication.
Supplied with antenna.
Please note! This board is normally soldered on top of another board. The pads at ... In stock -
RF Transceiver Aurel RTX-MID-5V 433.92MHz 650201044G
Aurel RTX-MID-5V RF Transceiver suitable for creating an RF Link circuit for use with, for example, Domoticz.
( See http://www.rflink.nl/blog2/wiring )
Mini ASK transceiver module with high sensitivity and power down
functionality - Ideal for a 2-way radio system needing to
save space and battery life. In compliance with European
Normative.
Aurel... In stock -
RF Transceiver module HC12 SI4463 433MHz
HC12 SI4463 433MHz RF transceiver module for long distance communication.
The HC-12 is a 100mW multi-channel wireless transceiver that you can use in your projects to send and receive serial information.
The HC-12 is a half-duplex wireless serial communication module with 100 channels in the range of 433.4-473.0 MHz that can transmit up to 1 km.
... In stock -
RF Transmitter Aurel TX-SAW-434-L 433.92MHz 650201409G
SAW oscillator transmitter module, operating at 434MHz in ASK
modulation.
Regulated power supply for operation up to 12V.
Ideal as a replacement of the model TX-SAW-433/sZ.
Aurel article number: 650201409G
In stock -
WiFi Antenna 2.4GHz SMA 2dB with uFL-SMA cable
2.4GHz antenna set of antenna with uFL-SMA connection cable.
The antenna has a male SMA connector, the cable has a female SMA connector and a female uFL connector on the other side.
Cable length: 14.5cm. In stock
Shipping costs Netherlands
>
