ZigBee / XBee
See also:
Domotica ZigBee
-
CC Debugger USB dongle for CC2531/CC2540
CC Debugger USB dongle for programming/flashing CC2531/CC2540 ZigBee sticks.
-
ZigBee CC2530 + CC2591 board with antenna
CC2530 ZigBee module with CC2591 amplifier and external antenna.
Compatible with ZigBee2MQTT (see left).
For instructions on how to provide the board with custom firmware for zigbee2mqtt so that you can use it with Domoticz and other home automation, see the following sites:
https://www.zigbee2mqtt.io/
You can also use an Arduino or an ESP8266 fo... -
ZigBee CC2530 board with antenna
This CC2530 board is a complete ZigBee / IEEE802.15.4 transceiver / sniffer with an 8051 CPU and is suitable for Zigbee2MQTT.
The board has a programming port and can be equipped with custom firmware that can serve as a ZigBee concentrator, for example. You can create your own ZigBee gateway and use it to control various devices such as lamps, tem... -
ZigBee CC2531 USB adapter stick/dongle extension cable/board
Board with cables for connecting a Zigbee CC2531 adapter
dongle on a programmer, Arduino or ESP8266.
The small pins on the dongle are normally quite difficult to connect, but with this board it is a lot easier.
In stock -
ZigBee CC2531 adapter USB stick/dongle with antenna
The CC2531 adapter USB dongle is a complete ZigBee / IEEE802.15.4 transceiver / sniffer with an 8051 CPU and a USB interface in one chip.
This version of the dongle has an antenna connector and an antenna.
The adapter stick has a programming port and can be equipped with custom firmware that can serve as a ZigBee concentrator, for example. You can... In stock -
ZigBee firmware flash service for ZigBee sticks
Order this article if you want us to flash your ZigBee stick with Zigbee firmware (Z-Stack Home 1.2 default version).
Suitable for ZigBee2MQTT and ZHA. Works with Domoticz and Home Assistant.
Only possible for sticks where this article is listed as an additional article.
Please allow 1-2 days longer delivery time due to flashing. In stock -
ZigBee/XBee Shield V03 for Arduino
Shield for the use of ZigBee/XBee modules.
Compatible with Series 1, Series 2.5, standard and Pro versions.
All pins of the Arduino are of course implemented. With reset button and switch to switch the communication of the ZigBee module between the USB port and the microcontroller.
Supplied without ZigBee/XBee module. In stock
Shipping costs Netherlands
>
